The white finish Nemesis is a 1:1 ratio mechanical mod clone. Constructed from stainless steel , this mod features silver plated contact pins, an adjustable airflow top cap and a spring firing button with locking. Extension tubes are offered in 3 different sizes, for batteries 18350, 18500, and 18650. Additionally, the white Nemesis clone is available in copper material with a white finish as well. The copper version in white finish is also equipped with copper contact pins for better conductivity.
- White SS (White Nemesis clone in stainless steel material / silver plated contact pins)
- White Copper (White Nemesis clone copper finish / copper contact pins)
- Stainless steel in white finish or copper in white finish
- Laser Etched Engraving
- Silver Plated Firing Pin or Copper Pins (White Copper option)
- Adjustabe Silver Plated Contacts or Copper (White Copper option)
- Firing Button Lock Feature
- Adjustable Air Flow w/Control Rings
- Extensions Tubes For Different Battery Sizes
- 510 Threaded Connector
There is a total of 7 pieces (top cap, bottom cap, 3 tubes, lock ring, beauty "kick" ring. The caps can be disassembled into additional pieces but generalized as 1 piece.
Note: please DO NOT stack batteries as this is a mechanical mod with no circuitry, you will effectively double your voltage which can and will destroy attached devices.
The all new v1.5 version has some improvements that enhances the performance even further from it's previous version. The Plume Veil v1.5 RDA clone is an excellent choice for a superior performance that packs many features. Each section of the atomizer from it's previous version has been carefully evaluated to seek further improvements from an already great performing RDA. The top cap now is equipped with 2 additional air holes versus it's previous 2, the body has a slightly larger air hole slit to squeeze extra air draw, and the deck has been upgraded with grooves to capture juice efficiently.
- 2 additional holes on top cap
- Longer air slits on body
- Grooved juice wells
- Stainless steel body
- 22mm diameter
- Dual, single or quad coil compatible
- Phillips screws
- Deep juice well
- Milled negative posts, no turning, EVER!
- Adjustable single or dual air-flow
- Unique airflow brings air from 3 places - slots in front of coils, holes through negative posts & holes in top cap for vacuum effect!
- Engraved logo (non logo version available as well)
- Delrin insulator
- Matching Plume Veil drip tip included
- Gold plated center pin, SS base
- Stainless steel positive block
- Plume Veil v1.5 RDA clone
- Drip Tip
- Extra O-Rings
- Extra Screws
Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.