The Fuhattan mechanical mod was an inspired version of the Manhattan mod. It consists of a 100% billet aluminum battery tube which houses a single 18650 sized battery. The design of the device has a thick wall design for added durability, a brass button switch backed by a super strong magnet as a firing switch. The magnetic strength allows the mod to stand upright without it autofiring, and the button assembly is designed with vented holes as an added feature. The top cap has a sliding pin to have promised contact between the battery and atomizer and both top and bottom pins are made from copper material for maximum conductivity.
- 100% aluminum billet body
- 100% brass firing button
- Standard painted finish (White and Tiffany-like finish is a smooth gloss texture)
- Super strong magnetic firing switch
- Copper contact pins
- Top atomizer sliding pin
- Accommodates 1 x 18650 battery
- 510 threaded connection
- Vented holes on button switch
Note: please DO NOT stack batteries as this is a mechanical mod with no circuitry, you will effectively double your voltage which can and will destroy attached devices. Also, have a clear knowledge of properly using mechanical mods.
The all new v1.5 version has some improvements that enhances the performance even further from it's previous version. The Plume Veil v1.5 RDA clone is an excellent choice for a superior performance that packs many features. Each section of the atomizer from it's previous version has been carefully evaluated to seek further improvements from an already great performing RDA. The top cap now is equipped with 2 additional air holes versus it's previous 2, the body has a slightly larger air hole slit to squeeze extra air draw, and the deck has been upgraded with grooves to capture juice efficiently.
- 2 additional holes on top cap
- Longer air slits on body
- Grooved juice wells
- Stainless steel body
- 22mm diameter
- Dual, single or quad coil compatible
- Phillips screws
- Deep juice well
- Milled negative posts, no turning, EVER!
- Adjustable single or dual air-flow
- Unique airflow brings air from 3 places - slots in front of coils, holes through negative posts & holes in top cap for vacuum effect!
- Engraved logo (non logo version available as well)
- Delrin insulator
- Matching Plume Veil drip tip included
- Gold plated center pin, SS base
- Stainless steel positive block
- Plume Veil v1.5 RDA clone
- Drip Tip
- Extra O-Rings
- Extra Screws
Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.