Capable of firing atomizers as low as 0.1 ohm and as high as 3.0 ohm, the SMY 50w Temperature Control box mod also allows you to set the temperature ranging from 200 to 400 degrees centigrade. The unit features a spring-loaded, stainless steel 510 connector and uses a single 18650 battery for power. There are numerous safety protection features on the SMY 50w Temperature Control box mod including over-temperature protection, anti-reverse protection, short-circuit protection, temperature control protection, low-voltage protecftion and timeout protection. The unit also has a USB charging port and uses a slide cover design to easily swap out the battery. On the front of the device is an LED display creen that shows voltage, wattage, atomizer ohm, temperature and battery life. Manufactured from Zinc Alloy, the SMY 50w Temperature Control box mod is lightweight and comfortable to hold.
As with all temperature control mods, it is required to use nickel atomizers when the unit has temperature control enabled. If using kanthal, ensure that the temperature control feature is turned off.
- Dual mode support - temperature control and variable wattainge power control
- Supports 0.1- 3.0-ohm atomizers
- USB charging port
- Zinc Alloy construction
- Slide cover and damping design
- LED display screen
- Spring-loaded, stainless steel 510 connector
- Over-temperature protection
- Anti-reverse protection
- Short-circuit protection
- Temperature control protection
- Low-voltage protection
- Timeout protection
Note: Batteries are not included. This unit is strongly recommended for advanced or experienced users. If you do not have an understanding of how to operate this unit, please ask questions or acquire a clear knowledge on how to operate these type of devices.
An original design by EHPro, the Revel Rebuildable Dripping Tank Atomizer (RDTA) is constructed of stainless steel and breaks down to six individual pieces: a drip tip, chimney, glass tank, mid section, deck and the "cooling" tube. The unit combines all the benefits of a tank and drippingatomizer into one while the deck of the Revel consists of three posts that allow for a variety of builds. When your wick gets dry, you can simply press down on the drip tip and liquid will drip into your build. The Revel also features an airflow control system to ensure you always get the perfect hit while the glass tank holds a 2.5ml capacity. The cooling tube features a heat sink while the 510 center pin is manufactured from copper. Measures in at 22mm in diameter and supports dual and quad coils.
- 22mm diameter so it fits flush on most 22mm mods
- Stainless steel and Pyrex glass construction
- Adjustable airflow control
- Dual- and quad-coil capabilities
- Top spring-loaded juice flow control
- 510 connection
- Three-post design to accommodate a variety of builds
- Innovative reservoir design that provides auto feeding of juice to your coils by pressing on drip tip
- Tank holds 2.5ml capacity
- 1x Revel RDTA by EHPro
- 1x bag of o-rings, wick and wire
- 1x screwdriver
Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.