SMY 50W Box Mod + Ehpro Little Boy RDA Clone

Price: $59.99 $54.99

Reward Points: 0

Available Options

* Chargers:


1 x


Capable of firing atomizers as low as 0.1 ohm and as high as 3.0 ohm, the SMY 50w Temperature Control box mod also allows you to set the temperature ranging from 200 to 400 degrees centigrade. The unit features a spring-loaded, stainless steel 510 connector and uses a single 18650 battery for power. There are numerous safety protection features on the SMY 50w Temperature Control box mod including over-temperature protection, anti-reverse protection, short-circuit protection, temperature control protection, low-voltage protecftion and timeout protection. The unit also has a USB charging port and uses a slide cover design to easily swap out the battery. On the front of the device is an LED display creen that shows voltage, wattage, atomizer ohm, temperature and battery life. Manufactured from Zinc Alloy, the SMY 50w Temperature Control box mod is lightweight and comfortable to hold.

As with all temperature control mods, it is required to use nickel atomizers when the unit has temperature control enabled. If using kanthal, ensure that the temperature control feature is turned off.


  • Dual mode support - temperature control and variable wattainge power control
  • Supports 0.1- 3.0-ohm atomizers
  • USB charging port
  • Zinc Alloy construction
  • Slide cover and damping design
  • LED display screen
  • Spring-loaded, stainless steel 510 connector
  • Over-temperature protection
  • Anti-reverse protection
  • Short-circuit protection
  • Temperature control protection
  • Low-voltage protection
  • Timeout protection

Note: Batteries are not included. This unit is strongly recommended for advanced or experienced users. If you do not have an understanding of how to operate this unit, please ask questions or acquire a clear knowledge on how to operate these type of devices.

With a cloud chaser in mind, the Atomic "Little Boy" RDA (rebuildable drip atomizer), cloned by Ehpro is one fine piece of unit. Equipped with 2 style drip tips, one with a large bore and another with adapter retrofitted for 510 style fitments, the stainless steel atomizer is a 22mm diameter design with a wide selection of features. Threee cyclops style air holes can allow adjustability for different air draw and a screw on top cap for each secureness. The three post design is great for an imaginative coil configuration setup, while the large post holes allow thicker gauge wire builds. Large juice well provide great liquid consumption with cotton / wick setups and the phillips screws make it easy to build as well.


  • 22mm diameter
  • Stainless steel material
  • Delrin wide bore drip tip (black)
  • Delrin adaptor for standard 510 drip tip
  • Adjustable air flow
  • 3 Cyclops style air slits
  • 2mm Post holes
  • 3 post design
  • Phillips screws
  • Large post holes
  • Deep juice well510 threaded connection


  • 1 x Little Boy RDA clone
  • 1 x Delrin Wide Bore Drip Tip
  • 1 x Delrin 510 Drip Tip Adaptor
  • Extra O-Ring
  • Replacement screws
  • Wick/Wire

Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.