The Caravela mod cloned by HCigar is a 1:1 ratio replica that is offered in either stainless steel or brass with mixed accents. Each mod is laser engraved with the 'ship' logo and other markings much like the original. The mechanical mod includes 3 different extension tubes for sizes that will fit for 18350, 18500, and 18650. On HCigar Caravela replicas, you will also receive a carrying case that has an embroidered HCigar logo.
- Stainless Steel or Brass w/mixed caps (brass tubes includes ss caps, ss tubes includes brass caps)
- Caravela ship logo on all battery tubes
- Signature Caravela "C" on ss button
- Signature "Pedro" logo on all battery tubes
- Individually numbered
- Silver plated contact pins
- Internal button switch and ring
- Recessed 510 atomizer connection
- Reverse threaded lock ring
- Adjustable 510 contact pin w/black delrin
- 22mm external diameter
- HCigar embroidered carrying case
Note: please DO NOT stack batteries as this is a mechanical mod with no circuitry, you will effectively double your voltage which can and will destroy attached devices. Also, have a clear knowledge of properly using mechanical mods.
Much like the Veritas RDA, the Marquis rebuildable atomizer consists of a few improvements that sets this apart. The first thing to notice is that this RDA has a dedicated air hole for each coil. Another bonus is the tools that's included to build each coil, making it simple to setup. The four building rods contain different mm diameters that can be placed into the holes on the atomizer. The crown design center post serves as a purpose to "trap" your wires into place, making it easy to tighten and secure. Along with the ease of mind in building coil configurations, the cap includes a threaded insulator which can be switched with 2 different types of 510 adapters, and 1 threaded drip tip. A flavorful RDA that is a must have for one who wishes to bear a simple coil build at the same time.
- 510 threading w/ fixed copper center screw
- 22mm outside diameter.
- 32.5mm overall height w/o drip tip
- Dual ground screws easy dual coil setup
- Dual coil/single coil capable
- Innovative crown style center post with wire capture tabs
- Vertical, horizontal or chimney coils
- Cotton, silica, SS mesh, etc. wicking
- Custom coiling rods in 2.5mm, 3.0mm, 3.5mm, 4.0mm diameters
- Blind holes in liquid well for perfect coil alignment
- 6mm deep liquid well (approx.)
- Double O-rings for a firm top cap seal
- Adjustable airflow ( single and dual coil mode)
- Removable lid (16mm) with heat insulator
- Custom wide bore drip tip (8.7mm bore)
- 2x custom lid adaptors for 510 style drip tips
- 1x Marquis RDA clone
- 1x PEEK drip tip adapter
- 1x 10mm wide bore drip tip ( 8.75mm Bore)
- 1x 4mm 510 drip tip adapter
- 1x Flush 510 drip tip adapter
- 2x 2.5 + 3mm coil building rods
- 2x 3.5 + 4mm coil building rods
- Extra O-rings
- Extra screws
Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.