The Buster mod minimizes voltage drop by integrating a hybrid style top cap allowing the atomizer to directly contact the battery. An included extension ring can accommodate 18650 batteries.
The Buster is made from stainless steel to further improve performance.
Additionally, it features a stainless steel bottom contact pin and a recessed magnetic firing button.
This full stainless steel mod includes ONLY the engraved Buster logo.
- 18500 or 18650 Compatible
- Hybrid Top Cap w/ 2 Air Holes
- 4 Air Hole in Tube
- Copper Bottom Contact
- Engraved Buster Logo Only
- Recessed Magnetiic Firing Button
- Full Stainless Steel
Note: please DO NOT stack batteries as this is a mechanical mod with no circuitry, you will effectively double your voltage which can and will destroy attached devices. Also, have a clear knowledge of properly using mechanical mods.
Featuring a two-post design, the Velocity RDA clone has unique side-mounted post screws with dual screw positive/negative posts. Measuring 22mm in diameter and 28mm in height without the drip tip, the Velocity RDA clone is constructed from 304 stainless steel and is one of the most versatile RDAs on the market when it comes to airflow control. The split cap design allows for a nearly infinite number of direct and indirect airflow adjustments, with dual 2mm x 8mm horizontal slots for direct air flow and 6 x 2mm fully adjustable indirect airholes. The RDA comes with a custom threaded large 12mm bore drip cap, removing the need for o-rings and is availble in either stainless steel or black. High temperature PEEK insulators are also incorporated into the Velocity RDA clone,l which has a large diameter 6.5mm deep open juice well.
- 304 stainless steel
- 22mm diameter
- 28mm height (without drip tip)
- Two-post design
- Unique side-mounted post screws
- Dual screw positive/negative posts
- Offset positive post (no center post)
- Solid copper center pin
- High temperature PEEK insulators
- 6.5mm deep juice well
- Dual 2mm x 8mm horizontal slots for direct airflow control
- Six 2mm fully adjustable indirect air holes
- Double o-rings for primary cap seal
- Custom threaded large 12mm bore drrip cap
- Custom threaded 510 drip tip adapter
- 1x Velocity RDA clone
- 1x Delrin wide bore drip tip
- 1x 510 drip tip adapter
- 1x Extra screws, o-rings and screwdriver
Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.